Wink of Stella have arrived!!

 Doing a little happy dance, we finally have Wink of Stella brushes in stock!

Wink of Stella Glitter brush pen is perfect for decorative lettering, drawing, and when used with stamped projects. Its nylon brush tip can produce different width of lines allowing artistic freedom. The water-based pigment ink is of archival quality, photo-safe, acid-free, xylene-free, and lightfast.

Find them in store here - Wink of Stella

HOW TO PRIME YOUR BRUSH

When you first use a Wink of Stella glitter brush, there are a few simple steps to follow before you get started. Be sure to follow this step-by-step guide on how to prime your brush.

The first thing you need to do is remove the black ring that is keeping the compartment holding the ink from being pierced. To do this you remove the cap and unscrew the top brush portion of the pen from the bottom ink cartridge. This will allow you to remove the black ring and discard it. Then re-screw the top brush portion of the pen back onto the ink cartridge; doing so will pierce it so that the ink can flow.

After, put the pen back together, replace the cap and shake the pen until you hear a clicking sound this indicates that the ink is mixed thoroughly.

Once this is done remove the cap again and gently squeeze the ink cartridge where it says “Push” on the side of the pen. This will cause the ink to start to fill the clear plastic area behind the brush tip. Be careful not to press too hard and overfill the ink, as it will cause the pen to leak.

When you are finished using your pen always replace the cap firmly and store the pen standing up with the cap facing upwards to ensure it lasts as long as possible.

Now that you’ve learned how to prime your brush, you are ready to apply glitter ink to any craft or stamping project...
Have Fun!